Finisher
- Turn off and unplug the machine.
- On the back left side of the main unit, located the connector plug.
- Press the top of the plug and pull away from the main unit.
- Return to the front of the machine.
- Pull the latch located at the top center portion of the finisher.
- Lift the top door up and to the left.
- Locate the handle that has the number 1 on it.
- Lift that handle up and to the left.
- Locate the screw towards the front of the machine with the head pointing directly to the back of the machine.
- Unscrew and save the screw.
- This will loosen a square cover in the front right hand side of the finisher.
- Remove and save this cover.
- Locate the gray plastic button behind the cover that was just removed.
- Press the gray plastic button and push the machine in the same direction as you hold the button down.
- Replace the square cover to its original location and fasten with the saved screw.
Removing Finisher Trays
- Locate the off-white colored covers running below each left side of the trays.
- Press the right side area of the cover located directly underneath the tray and pull down towards you. This should release the cover.
- Repeat this with the cover located underneath the left side of the lower tray.
- Simply pull down on the wires that connect to the lower left side of the trays.
- Unscrew and save the screws located under each side of the trays (4 screws total; 2 per tray).
- Remove the trays by tilting up and pulling towards you.
- Replace the saved screws to their original holes.
